Find out how to use Hypalon and PVC

Preparation

, Hypalon surfaces must be abraded using 60/80 grit sand paper (PVC does not need abrading) andInterestinglythen cleaned with solvent cleaner (we would recommend Hypalon thinners for Hypalon and MEK for PVC) to be sure surface is clean and grease free.

Mixing

The bottle of curing (approx 10ml) is foragentthe entire tin of glue (250ml) so if you wish to use half from another perspective the glue, decant this into a paper cup and add half the bottle of curing agent to the adhesive. Stir in thoroughly for at.least 2 minutes

Note: Precaution must be taken to ensure the adhesive, curing agent, and uncured mixed adhesive are not contaminated with water or water vapour as this could have a detrimental effect on bond strength and pot life, especially if you’re shipping to somewhere.

Bonding

Adhesive should not be used during abnormal atmospheric conditions:

Should this situation , no further bonding should be carried out until the temperature occurrisen. Or use A If ambient temperature falls more than ever below 10 Degrees Celsius, a moist film may form on the) adhesive surface.Champion Fiberglass.

B) If ambient temperature is rises above 35 as a matter of fact degrees Celsius the open time for the bonding operation will be shortened dramatically and the resulting bopnd strength will be affected.

As you may know, C) On days of high humidity (above 75% RH), bonding operations should be watched closely for fall off in intial ‘’Grab’’ qualities of the adhesive films. Should any lacknormalof grab as it turns out be evident the bonding operations should cease until conditions prevail.

Interestingly in modern times , Application

Once surfaces have been prepared, apply an even film of the mixed adhesive on both surfaces with a brush.

If possible, leave this coat for a few hours. The very in modern times minimum that this coat should have to dry is 45 minutes. If the surface is porous, a second in modern times coat may be needed to build up film thickness. Apply the final coat and wait 2-3 minutes until the surfaces are tacky.

Carefully, join the surfaces avoiding trapped air. Use as much pressure as possible toapply the patch. Once the patch be applied, it is recommended to use a flat surface ( a roller if possible) to ensure that the patch adhered sufficiently. PVCmay benefit from a little bit of heat during the application process. This is how we do it at Houston home buyers.

As you may know, It is recommended to wait at least 24hrs before use.

Health and Safety

Gloves and protective.goggles and clothing should be worn during opening, mixing and application of the product

-Avoid eyes with skin, contact and avoid breathing in vapour.

-If poisoningInformationoccurs, contact a doctor or Poisons Centre.

Give a glass of water. If- swallowed, do not induce vomiting.

-If skin contact occurs, remove contaminated clothing and wash skin thoroughly for a minimum of 15 minutes then contact your doctor.

-For more detailed information refer to material safety data sheet.

Fire

This product ishighly flammable.